Aicox Soluciones and Mitsubishi Electric present the new SLIMDIP-Z module
Mitsubishi Electric expands its SLIMDIP range and reaches up to 30 amps of nominal current with a new intelligent module in 30A/600V SLIMDIP package.
By reducing thermal resistance and motor noise, the SLIMDIP-Z is presented as a solution for inverter systems that need to reach up to this current range and simplify and reduce the size of the inverter.
MAIN FEATURES:
- Insulation improvements reduce thermal resistance between chip and capsule by 40% compared to the existing 15 amp SLIMDIP-L, increasing current rating to 30 amps.
- The motor noise reduction technology implemented in the RC-IGBTs (Reverse Conducting-IGBTs) helps to reduce the number of noise-suppressing components on the board, which will facilitate the design of inverter systems of smaller size and cost.
SPECIFICATIONS:
model
SLIMDIP-Z.
application
Home air conditioners, washing machines, etc.
dimensions
18.8 x 32.8 x 3.6mm
Rating voltage
600V.
Rating current
30A.
built-in chips
Three-phase inverter bridge with built-in RC-IGBT, HVIC, LVIC and bootstrap diode chips.
functions
– Short-circuit (SC) protection by means of router shunt resistor.
– Controlled power sluppy under-voltage (UV) protection. For output on N-side.
– Over-temperature protection (on N-side).
– Analog temperature voltage output (VOT).
shipments
From February 2023.
other
Open-emitter N-side IGBT.
The SLIMDIP series offer encapsulation compatibility in dimensions and pin out in its entire range from 5 to 30 amps.
This new SLIMDIP-Z module addresses the market demands for higher power inverter systems, mainly for washing machines, air conditioners, white goods and small capacity general purpose motors.
